position:home > product center > Tyre Recycling Production Line >

Continuous Waste Tyre Pyrolysis Plant

Pyrolysis Plant is used for recycling waste tire, waste plastic, waste rubber to fuel oil. According to the actual situation in every country and district, we developed different models of Batch Pyrolysis Plants for waste tires, rubber and p

Pyrolysis Plant is used for recycling waste tire, waste plastic, waste rubber to fuel oil. According to the actual situation in every country and district, we developed different models of Batch Pyrolysis Plants for waste tires, rubber and plastic with daily capacity 25-40 tons.
 
Flowchat of Continuous Waste Tyre Pyrolysis Plant
 

 
Advantages of Continuous Waste Tyre Pyrolysis Plant

1. Large daily capacity of 25 MT raw materials, and can work 24 hours without any stop for 15-20 days;
2. Auto-loading, auto-discharging and oil coming out at the same time;
3. Only need fuel for the beginning 2-3 hours, then the sync gas generates itself is enough to support heating, saving fuel cost;
4. Low requirement on the raw materials, no need tiny granule, 5cm pieces acceptable for smooth running;
5. High efficiency condensers, more oil output, good quality oil, easy to clean.
6. Sync gas recycling system, fully burned after recycling and utilization, preventing pollution and saving fuel cost.
7. National patent smoke scrubber, can efficient remove the acid gas and dust of the smoke, environmental friendly to meet related national standards.
8. Easy to operate, need less manpower.

Technical Parameter of Continuous Waste Tyre Pyrolysis Plant

NO. ITEM Technical Parameter
1 Suitable Raw Materials Small pieces of Waste tyre,rubber, waste plastic≤5cm
2 Operating Mode Fully Continuous Operation
3 Structure Horizontal Type Revolve
4 Loading and discharging Fully Automatic Feeding and Discharging under High Temperature at Same Time
5 Capacity(24h) 10-40Mt
6 Work Pressure Slightly Negative Pressure
7 Oil Yield of tyres 40%-45%
8 Reactor Rotational Speed 1R/M
9 Installation Power 110kw
10 Cooling Method Cycle water
11 Type of Drive Sprocket Wheel
12 Heating Method Hot Air
13 Noise dB(A) ≤85
14 Main Reactor Weight (MT) About 20Mt
15 Total Weight(MT) About 45Mt
16 Installation Space Required 60m*20m
17 Manpower 2/shift
18 Shipment 5*40HC
19 Delivery time ≤70Days
 
The Parameter of the tire oil after pyrolysis should be:

No. Project Tire oil Plastic Oil
1 Water content 3% - 5% 3% - 5%
2 Sulfur content 0.3% ≤0.5%
3 Density 0.88-0.92 0.84-0.88
4 Cetane number 30 30
5 Combustion value 9500 9000
6 Asphalt 0.5% 0.5%
7 Ash   1% /
8 Impurity 1%- 3% /
9 Solidifying point -10℃ 10℃
10 Flash point   30℃ 20℃





link:http://uviolet.nl//product_center/Tyre-Recycling-Production-Line/136.html